Entering The Ip Address - Kyocera FS-2100DN Operation Manual

IPv4 Setting:
1
********************- DHCP
2
Auto-IP
3
IP Address

Entering the IP address

If DHCP is set to Off, enter the IP Address manually.
IP Address:
/**0. 0.
IPv4 Setting:
1 DHCP
2
Auto-IP
3 IP Address
********************-
Entering the Subnet Mask
When DHCP is set to Off, enter the Subnet Mask manually.
Subnet Mask:
/**0.
0.
IPv4 Setting:
********************- 4 Subnet Mask
5 Default Gateway
6
Bonjour
14
a b
[ Exit ]
15
16
a b
0. 0
17
18
a b
[ Exit ]
19
20
a b
0. 0
21
22
a b
[ Exit ]
Press [OK]. The DHCP setting is set and the IPv4 Setting menu
reappears.
Note DHCP becomes effective when On is selected. Press
[Menu] to end the mode selection menu.
When Off is set, continue on to enter the IP Address.
Press  or  to select IP Address.
Press [OK]. The IP Address screen appears.
Use the numeric keys or  or  to set the IP address.
You can set any value between 000 and 255.
Increase or reduce the figures by pressing  or .
Use  and  to move the position being entered, which is shown
highlighted.
Press [OK]. The IP address is stored and the IPv4 Setting menu
reappears.
Press  or  to select Subnet Mask.
Press [OK]. The Subnet Mask screen appears.
Use the numeric keys or  or  to set the subnet mask.
You can set any value between 000 and 255.
The method for entering is the same as for the IP Address.
Press [OK]. The subnet mask setting is stored and the IPv4
Setting menu reappears.
2-5
Preparation before Use