Kyocera FS-2100DN Operation Manual page 227

Delete a File
Delete the file(s) selected in the Job Box.
l User01:
1
********************- Print
2
Delete
Delete.
Are you sure?
z Q Data01.doc 120313
[ Yes ] [
Completed.
Private/Stored (Printing a Private Print/Stored Job)
In private printing, you can specify that a job is not printed until you release the job from the operation panel. When sending
the job from the application software, specify a 4-digit access code in the printer driver. The job is released for printing by
entering the access code on the operation panel ensuring confidentiality of the print job.
In the stored job mode, access codes are not mandatory, but can be set on the printer driver if printing with PIN security is
required. Then, the access code must be entered on the operation panel to print a stored job. Print data will be stored in the
SSD, SD/SDHC memory card or RAM disk after printing.
Note Refer to the Printer Driver User Guide for the driver settings.
The following operations are possible:
• Printing a Private/Stored Job...5-31
• Print a File...5-32
• Deleting a Private/Stored Job...5-33
• Delete a File...5-34
Printing a Private/Stored Job
Select the checkmarked file and press [Select] ([Right Select])
again to cancel the selection.
Note To select all files, follow the steps of Select/Deselect All
Files on page 5-26
1
In the file list screen, select the item and press [OK]. The Print/
a b
Delete menu screen appears.
2
Press  or  to select Delete and press [OK]. A confirmation
screen appears.
No ]
3
Press [Yes] ([Left Select]). The message Completed. appears
and the selected job is deleted.
Pressing [No] ([Right Select]) returns to the file list screen.
1
In the Job Box menu, press  or  to select Private/Stored.
5-31
Document Box