Modifying Or Deleting Registered Information - Kyocera KM-2540 Operation Manual

Register the dial.
One-Touch Key0001.
Subaddress TX
Enter using # key.
Subaddress _.
Off
Password
On
Register the dial.
One-Touch Key0001.
Encryption
Enter using # key.
Encryption
00.
Key No.
Off
Encryption
0000.
box #
On
Ready for fax transmission.
Place the original & assign destination.
Dest
Address TX
Abbrev.
book setting
Basic Application
2-18
12
13
Ba
Dele
14
15
16
17
Ba
18
19
20
21

Modifying or Deleting Registered Information

1
2
Register Print Report
To use this key for F-Code Based Communication, press the [On]
key. The Subaddress/Password Input screen will appear.
Use the numeric keys to enter the desired subaddress and F-Code
password. (Maximum 20 digits)
Note To switch between the subaddress and password input
screens, press the [Password] key.
A subaddress is required during F-Code Based
Communication in order to designate the other party's
corresponding F-Code Box.
An F-Code password is used during F-Code Based
Communication. However, you do not have to enter an F-
Code password here if you have determined in advance with
the other party not to use one.
Press the [Close] key twice and then go directly to step 20.
If you want to designate this key for Encrypted Transmission, press
the [Encryption TX] ([Encryption]) key.
To use this key for Encrypted Transmission, press the [On] key. The
Key Number/Box Number Input screen will appear.
Use the numeric keys to enter the 2-digit Key Number (01 - 20) that
corresponds to the Encryption Key you want to use for this one-
touch key.
Press the [Encryption box #] key and then use the numeric keys to
enter the number of the destination party's Encryption Box.
Press the [Close] key twice.
To register this one-touch key with the entered information as is,
press the [OK] key.
The message display will return to the same screen as was
displayed in step 3.
If you want to continue registering other one-touch keys, repeat
steps 3 through 20.
If you are finished making settings, press the Reset key to return to
the initial mode.
Note If the one-touch key that you want to modify is designated for
F-Code Based Communication, you will NOT be able to change
the designation of that key into one for Encrypted Transmission.
Likewise, if it is designated for Encrypted Transmission, you can
NOT change the designation into one for F-Code Based
Communication.
Press the [Register] key. The Register screen will appear.
Press the [Dial] key.
Fax Operation (Basic)