Kyocera KM-2540 Operation Manual page 40

Storing data into memory
Continue scanning?
Yes
2-8
If the Documents Were Set on the Platen...
Whenever you set the documents that you want to transmit on the
platen, close the Document Processor in order to allow the machine
to detect the size of those documents. If you are transmitting
information from books or other types of documents that will not
allow you to close the Document Processor, it is necessary to
indicate the document size manually. (Refer to page 2-6.)
> If you have more documents to send...
1 Set the next page to be scanned on the platen.
2 Press the [Yes] key.
No
3 Press the [Start] key.
> Once there are no further pages to be scanned...
Press the [No] key. Transmission of the documents will begin
automatically.
Note In addition, any time you set documents on the platen for
transmission, a menu like that shown below will appear in the
message display once you press the Start key and the
documents have been scanned. In this case, perform the
following procedure.
Note The next document(s) may also be set in the
Document Processor.
Note If you set the document(s) in the Document
Processor, scanning and then transmission of the
documents will begin automatically.
Repeat steps (1) through (3) for all remaining documents.
Fax Operation (Basic)