Assembling The Inner Rails On A San Switch With Plenum - HP AA979A - StorageWorks SAN Switch 2/8V Installation Manual

Installing the SAN Switch
Note:
SAN switch 2/16V or 2/16N are installed in an HP 9000 or 10000 serires, System/e
or comparable EIA cabinet.
The plenum allows air to dissipate at the rear of the rack, preventing overheating. If the
Plenum is not pre-installed, refer to
Figure 11: Assembling the inner rails on a SAN Switch with plenum
The components in
1
2
7. Insert the switch with the attached inner rails into the outer rails.
44
b. For the SAN Switch 2/8V, assemble the two inner rails (one on each side)
to the switch and plenum using the appropriate number (from
page 42) of #8-32 x 5/16-inch Phillips pan-head SEMS screws as shown
in Figure 11.
The plenum is a required part of this installation when the SAN switch 2/8V,
Figure 11
Plenum
Switch
step b on page 44 for instructions.
1
include:
SAN Switch 2/8V, 2/16V and 2/16N Installation Guide
step 5 on
2
0013a