Chapter 2
Ethernet Switching Modules
Table 2-13
WS-X6148-RJ-21 Ethernet Modules Features (continued)
Feature
Chassis/slot restrictions
Bus connection
Daughter card support
PoE support
Distributed forwarding
support
Pluggable transceivers
support
TDR support
Module front panel LEDs
OL-6265-03
Description
No chassis or slot restrictions; the module can occupy any slot in any
Catalyst 6500 or Catalyst 6500-E chassis (all variants).
Single connection into the 32-Gbps shared bus (all variants)
WS-X6148-RJ-21—Field upgradeable to Cisco Prestandard only by
installing the WS-F6K-VPWR= daughter card.
Refer to the Cisco Catalyst 6500 Series Power over Ethernet Daughter
Cards Field-Upgrade Installation Note for field upgrade procedures.
An IEEE 802.3af standard PoE daughter card is available
Note
through factory advance replacement only; the IEEE 802.3af
standard PoE daughter card is not field upgradeable.
Not available.
Not supported.
All variants supported.
STATUS
•
Green—All diagnostics pass; the module is operational.
Orange—The module is booting or running diagnostics; an
•
overtemperature condition has occurred.
LINK
•
Green—The port is active (the link is connected and operational).
Flashing orange—The port failed diagnostics and is disabled.
•
Orange—The port is disabled.
•
Red—The module is resetting; an overtemperature condition has
•
occurred.
If the module fails to download code and configuration
Note
information successfully during the initial reset, the LED stays
red; the module does not come online.
Off—The port is not active or the link is not connected.
•
PHONE
Green—The PoE daughter card is installed and detected.
•
Off—The PoE daughter card is not detected or is not installed.
•
10/100 and 10/100/1000 Ethernet Modules
Catalyst 6500 Series Ethernet Modules Installation Guide
2-21