Cisco 6513 - Catalyst Switch Installation Manual page 229

Appendix B Pluggable Transceiver Modules
Table B-18 WDM Transceivers (continued)
WDM Transceiver Description
Type
CWDM SFP The Coarse Wavelength Division
Multiplexing (CWDM) SFPs are
hot-swappable, transceiver components
that you plug into SFP-compatible
modules and supervisor engines. The
CWDM SFP transceiver uses an LC
optical connector to connect to
single-mode fiber-optic (SMF) cable.
You can connect the CWDM SFPs to
CWDM passive optical system optical
add/drop multiplexer (OADM) modules
or multiplexer/demultiplexer plug-in
modules using single-mode fiber-optic
cables.
DWDM XENPAK DWDM XENPAK transceivers are used
as part of a DWDM optical network to
provide high-capacity bandwidth across
an optical fiber network. There are 32
fixed-wavelength DWDM XENPAK
transceivers that support the
International Telecommunications
Union (ITU) 100 GHz wavelength grid.
The DWDM XENPAK transceivers
have a duplex SC connector.
R/O WDM The R/O WDM XENPAK receiver
XENPAK (WDM-XENPAK-REC) operates as a
pluggable receiver on any
unidirectional link in a CWDM or
DWDM transport network; there is no
transmitter in the XENPAK. The
receiver can be used for all wavelengths
supported by Cisco DWDM XENPAK
transceivers. The W/O WDM receiver
has a single SC connector.
1. Not all WDM transceivers may be supported on the modules. Refer to your software release notes for specific information on which WDM transceivers
are supported and the software release level necessary to support them.
OL-6265-03
Supported on these
1
Modules
• WS-X6724-SFP
• WS-X6748-SFP
WS-X6704-10GE
•
WS-X6704-10GE
•
Catalyst 6500 Series Ethernet Modules Installation Guide
WDM Transceivers
WDM WDM Transceiver
Transceiver Specification
Illustration Table
Figure B-11 Table B-21
Figure B-12 Table B-22
— —
B-17