Cisco 6513 - Catalyst Switch Installation Manual page 153

Chapter 2 Ethernet Switching Modules
Table 2-48 WS-X6748-SFP Features (continued)
Feature
Software support
Queues per port
Chassis/slot restrictions
Fabric connection
Fabric channel speed
Module upgrades available
PoE support
Distributed forwarding
support
Pluggable transceivers
support
OL-6265-03
Description
With Supervisor Engine 720—12.2(17d)SXB
•
With Supervisor Engine 720 and DFC3C or
•
DFC3CXL—12.2(33)SXH
With Supervisor Engine 720-10GE—12.2(33)SXH
•
With CFC daughter card:
•
Tx—1p3q8t
–
Rx—1q8t
–
With DFC daughter card:
•
Tx—1p3q8t
–
– Rx—2q8t
The module is not supported in the Catalyst 6503 switch chassis.
•
The module can occupy any slot in any other Catalyst 6500 or
•
Catalyst 6500-E chassis with the exception of the Catalyst 6513
chassis where the module must be installed only in slots 9–13. The
module will not power up if it is installed in slots 1–8.
• Dual switch-fabric connections:
– Fabric channel 1—Ports 2, 4, 6, 8, 10, 12, 14, 16, 18, 20, 22,
24, 26, 28, 30, 32, 34, 36, 38, 40, 42, 44, 46, 48
– Fabric channel 2—Ports 1, 3, 5, 7, 9, 11, 13, 15, 17, 19, 21, 23,
25, 27, 29, 31, 33, 35, 37, 39, 41, 43, 45, 47
20Gb/sec
Not supported.
Ships with the WS-F6700-CFC daughter card factory-installed. The
module can be upgraded in the field to support dCEF with the
installation of a dCEF daughter card (WS-F6700-DFC3A,
WS-F6700-DFC3B, WS-F6700-DFC3BXL, WS-F6700-DFC3C, or the
WS-F6700-DFC3CXL).
Refer to the Catalyst 6500 Series DFC3A, DFC3B, and
Note
DFC3BXL Installation Note for additional information and
field upgrade procedures.
SFP transceivers are supported. Refer to your software release notes to
determine which SFP transceivers are supported. See the
Transceivers" section on page B-3
information on the SFP transceivers.
"1-GB
in Appendix B for additional
Catalyst 6500 Series Ethernet Modules Installation Guide
1-Gigabit Ethernet Modules
2-79