Cisco 6513 - Catalyst Switch Installation Manual page 183

Chapter 3 Installing Ethernet Switching Modules
c.
Figure 3-2 Clearing the EMI Gasket in a Horizontal Slot Chassis
WS-X6K-SU P2-2GE
1
SUPERVIS OR2
WS-X6K-SU P2-2GE
2
SUPERVIS OR2
3
Press down
4
WS-X622 4
5
24 PORT 100FX
6
3
4
4
WS -C6 500 -SF
M
5
5
SW ITC H FAB IRD
MD L
6
6
d.
e.
OL-6265-03
Using the thumb and forefinger of each hand, grasp the two ejector levers and gently press down to
create a small 0.040 inch (1 mm) gap between the module's EMI gasket and the module or cover
plate above it. (See Figure
Note Do not press down too forcefully on the levers because they will bend and get damaged.
CONSOLE
PORT
MODE
CONSOLE
PCMCIA
EJECT
CONSOLE
PORT
MODE
CONSOLE
PCMCIA
EJECT
While gently pressing down, simultaneously close the left and right ejector levers to fully seat the
module in the backplane connector. The ejector levers are fully closed when they are flush with the
module faceplate. (See Figure
Failure to fully seat the module in the backplane connector can result in error messages.
Note
Tighten the two captive installation screws on the module.
Make sure the ejector levers are fully closed before tightening the captive installation
Note
screws.
3-2.)
Switch Load
100%
PORT 1
PORT 2
1%
Switch Load
100%
PORT 1
PORT 2
1%
Press down
1 mm Gap between the module
EMI gasket and the
module above it
3-3.)
Catalyst 6500 Series Ethernet Modules Installation Guide
Installing an Ethernet Switching Module
3-5