Installing Ethernet Switching Modules
This chapter describes how to safely install, remove, and verify the operation of the Ethernet switching
modules in the Catalyst 6500 series switches, and it contains these sections:
•
•
•
•
•
•
•
Safety
Safety warnings appear throughout this publication in procedures that may harm you if performed
incorrectly. A warning symbol precedes each warning statement. The warnings below are general
warnings that are applicable to the entire publication.
Class 1 laser product. Statement 1008
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Before opening the unit, disconnect the telephone-network cables to avoid contact with
Warning
telephone-network voltages. Statement 1041
OL-6265-03
Safety, page 3-1
Installing an Ethernet Switching Module, page 3-2
Removing an Ethernet Switching Module, page 3-10
Installing Pluggable Transceivers, page 3-11
Attaching the Network Interface Cables, page 3-22
Verifying the Installation, page 3-25
What To Do After Installing Modules and Verifying Connectivity, page 3-27
C H A P T E R
Catalyst 6500 Series Ethernet Modules Installation Guide
3
3-1