Removing A Pretranslator From The Dial Plan; Configuring The Dial Plan For The 4Ess Protocol (T1) - 3Com 3C10402B Administrator's Manual

300 C 11: D
HAPTER IAL
Removing a
Pretranslator from
the Dial Plan
Configuring the
Dial Plan for the
4ESS Protocol (T1)
P
LAN
5 Click Apply to make the changes and keep this window open, click OK to
make the changes and close the window, or click Cancel to return to the
previous window without putting the changes into effect.
To remove a pretranslator:
1 Click Dial Plan > Pretranslators and select a pretranslator from the scroll
list.
2 Select the pretranslator, or pretranslators, that you want to delete and
click Remove Selected. To select all pretranslators, enable the Select check
box.
3 Click OK.
CAUTION: You cannot remove a pretranslator if any device is currently
using it. If you want to remove the pretranslator, first remove all devices
from the Devices Using list.
The 4ESS protocol, used on T1 Digital Line Cards that are configured for
PRI operation, requires specific configuration entries in the system dial
plan. If you purchase the 4ESS protocol and SDN (Software Defined
Network) service from your long-distance carrier, you must make dial plan
changes similar to those outlined in
Calls" on page
international long distance calls using the 4ESS protocol, you must make
dial plan changes similar to those outlined in
for North American Long Distance"
Dial Plan for International Long Distance"
Configuring the Dial Plan for SDN Calls
If you use the 4ESS protocol and want to make SDN calls, in the system
dial plan, configure a unique route to use for SDN calls and include the
letters SDN at the beginning of the dial string.
Example: The dial plan entry shown in
SDN, which must be upper case letters, before the long-distance dialed
digits. This example assumes that SDN calls use route 4.
300. If you want to make long distance calls or
"Configuring the Dial Plan for SDN
"Configuring the Dial Plan
on page 301 and "Configuring the
on page 301.
Figure 16 adds the characters