Using The Zoning Page
Figure 4-3
Select Configure > Zoning on the navigation panel. The Zoning
configuration page
(Figure
configure zoning on the product. The page has three panels:
•
Potential Zone Members—Used to add members to the zone. This
consists of a listing of attached nodes and an interface for adding
zone members by WWN or the combination of domain ID and
port number.
•
Zone Name—This panel is used to create and modify zones. The
list of zone members shown in the Pending Zone Members area is
pending in the sense that it is a work area; changes made in this
area are not saved until the zone is added into a zone set.
•
Zone Set—This panel is used to create and modify zone sets.
Changes made in this panel are not made active in the fabric until
they are activated using the Activate button.
Arrow buttons are used to move items between the panels. Zone
members are added and deleted from the zone using the arrow
buttons. Zones are added to the zone set using the arrow buttons.
Zoning Page
4-3) displays. This page is used to
Configuring Zoning
Using The Zoning Page
4-13
4