Starting The Efcm Basic Interface; Enter Network Password Dialog Box - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Starting the EFCM Basic Interface

Figure 1-1
Open the EFCM Basic interface as follows:
1. You must be able to make a connection between the web browser
and the product in order to log into the product. Ensure the
workstation (or device you use to launch the web browser) and
the Ethernet LAN segment containing the product, such as the
24-Port Switch, are attached and connected through the Internet.
2. Launch the web browser application (such as Netscape
Navigator, version 7.0 or higher, or Microsoft Internet Explorer,
version 6.0 or higher).
3. At the web browser, enter the IP address of the product as the
Internet uniform resource locator (URL) such as http://10.1.1.11.
For the ES-1000 Fabric Switch, the Enterprise Fabric Connectivity
Manager (EFCM) and SANavigator SAN management tools
provide a menu link that opens the web browser and connects to
the EFCM Basic interface.
NOTE: If the product has not been installed, refer to the product's
installation and service manual for the default IP address, login ID, and
password to use during installation.
4. After a connection is made between the web browser and the
product, the Enter Network Password dialog box displays as shown
in Figure 1-1. The dialog box may look different depending upon
your system but in all cases, you need to enter a user name and
password.

Enter Network Password Dialog Box

Starting the EFCM Basic Interface

Introduction
1
1-7