Configuring Cli And Ssh - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Configuring CLI and SSH

5. For each trap recipient to be configured, type a community name
of 32 or fewer alphanumeric characters in the Name field. The
community name is incorporated in SNMP trap messages to
prevent unauthorized viewing or use. Duplicate community
names are allowed, but the corresponding Write Authorization
check boxes must match.
TIP: Spaces are allowed in the Name field.
6. Click the check box in the Write Auth column to enable or disable
write authorization for the trap recipient (default is disabled). A
check mark indicates write authorization is enabled. When the
feature is enabled, a management workstation user can change
sysContact, sysName, and sysLocation SNMP variables.
7. Type the IP address or DNS host name of the trap recipient
(SNMP management workstation) in the Trap Recipient field in
four-byte, dotted-decimal format with a maximum of 16
characters. It is recommended the IP address be used.
8. The default UDP port number for trap recipients is 162. Type a
decimal port number in the UDP Port field to override the default.
The range for the UDP port number value is 1 to 65535.
9. Click OK to save and activate the changes. The message Your
changes have been successfully activated displays below the
page's heading.
Perform this procedure to enable (activate) or disable (deactivate) the
state of the product's command line interface (CLI), as well as to
configure the secure shell (SSH), which is used to provide secure
access and encrypted data when using the SSH function. To enable or
disable CLI as well as enable SSH, use the procedures that follow:
1. Select Configure > CLI on the navigation panel. The CLI
configuration page (Figure 3-10) displays.
Configuring the Product

Configuring CLI and SSH

3-19
3