Configuring Network Parameters For The Switch - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Configuring Switch Information
3
Configuring
Network Parameters
for the Switch
EFCM Basic User Manual
3-16
• Open Fabric 1.0—Select this option for managing
heterogeneous fabrics, and if the product is fabric-attached to
McDATA directors or switches and open-fabric compliant
switches produced by other original equipment
manufacturers (OEMs). This setting is the default.
7. Click OK to save and activate the changes. The message Your
changes have been successfully activated displays below the
page's heading.
8. If the product is offline, set the product online by selecting the
Switch Online check box on the Configure menu.
Verify the type of LAN installation with the customer's network
administrator. If one McDATA product is installed on a dedicated
LAN, network information (IP address, subnet mask, and gateway
address) does not require change.
If multiple McDATA products are installed or a public LAN segment
is used, network information must be changed to conform to the
customer's LAN addressing scheme.
Perform the following steps to change a product's IP address, subnet
mask, or gateway address.
1. Select Configure > Switch > Network on the navigation panel. The
Switch Network configuration page
1. The Operation Mode parameter of the EFCM Basic interface is equivalent
to the Management Style parameter of the Element Manager interface of
SANavigator. The S/390 Mode used for the EFCM Basic interface is
equivalent to the FICON management style on the Element Manager.
(Figure 3-8) displays.