Single Controller Configuration With Basic Profile Group - NETGEAR WC7520 - ProSafe 20-AP Wireless Controller Reference Manual

ProSafe 20-AP Wireless Controller WC7520 Reference Manual
For information about how to configure authentication servers, see
Servers and Authentication Server Groups

Single Controller Configuration with Basic Profile Group

A basic configuration consists of a single wireless controller that controls a collection of
access points that are organized into the basic default group.
To set up a single wireless controller system with a basic profile group:
Step Configuration
1. Optional: Create an RF plan.
2. If you have not yet done so, configure the system settings of the
wireless controller:
1. Configure the country code of operation.
2. Configure the IP address of wireless controller.
3. Verify that VLAN 1 is set as the management VLAN and is
marked as untagged, which is the default setting.
3. Configure up to 8 profiles, and for each profile, do at least the
following:
1. Configure an SSID for wireless access.
2. Configure the network authentication and data encryption.
3. Assign the VLAN.
If required, configure the authentication server.
4. Run the Discovery Wizard and add the access points to the
managed access point list.
on page 95.
Chapter 2: System Planning and Deployment Scenarios
Managing Authentication
Web Management Interface Path
Plans > Layout
Configuration > System > General
Configuration > System > IP/VLAN
Configuration > Profile > Basic
Configuration > Security > Basic >
Authentication Server
Access Point > Discovery Wizard
| 25