Partiaload Command Line - Autodesk AUTOCAD 2006 Command Reference Manual

PARTIALOAD Command Line

When a drawing is partially open and you enter -partiaload at the Command
prompt, PARTIALOAD displays prompts on the command line.
Specify First Corner or [View]: Specify a point or enter v
First Corner
Specifies the first corner of a user-defined view.
Specify opposite corner: Specify a point
Geometry from the defined view is loaded into the partially open drawing.
Enter layers to load or [?] <none>: Enter a layer name, enter ? , or press ENTER
Layers to Load
Loads geometry from the selected layers into the current drawing, including
both model space and paper space geometry. To load geometry from multiple
layers into the drawing, use a comma between layer names. If no layer
geometry is specified, no layer geometry is loaded into the drawing, including
geometry specified to load from a view.
Unload all Xrefs on open [Yes/No] <Yes>: Enter y or n , or press ENTER
Yes
Does not load any external references into the drawing.
No
Loads all external references into the drawing.
?—List Layers
Displays a list of layer names available in the current drawing. Enter one or
more layer names. If no layer geometry is specified, no layer geometry is loaded
into the drawing, including geometry specified to load from a view.
Unload all Xrefs on open [Yes/No] <Yes>: Enter y or n , or press ENTER
Yes
Does not load any external references into the drawing.
No
Loads all external references into the drawing.
PARTIALOAD Command Line | 831