Enter name(s) of viewport configuration(s) to list <*>: Enter a name or press
ENTER
The lower-left and upper-right corners of the viewport define its location.
For these corners, values between 0.0,0.0 (for the lower-left corner of the
drawing area) and 1.0,1.0 (for the upper-right corner) are used. The current
viewport is listed first.
2
Divides the current viewport in half.
Enter a configuration option [Horizontal/Vertical] <Vertical>: Enter h or press
ENTER
3
Divides the current viewport into three viewports.
Enter a configuration option [Horizontal/Vertical/Above/Below/Left/Right]
<Right>: Enter an option or press ENTER
The Horizontal and Vertical options split the area into thirds. The Above,
Below, Left, and Right options specify where the larger viewport is placed.
4
Divides the current viewport into four viewports of equal size.
VPORTS Command Line - Layout Viewports
If you enter –vports at the Command prompt from a layout tab, VPORTS
displays prompts on the command line.
Specify corner of viewport or
On/Off/Fit/Shadeplot/Lock/Object/Polygonal/Restore/2/3/4 <Fit>: Specify a point
or enter an option
The number and layout of active viewports and their associated settings are
called viewport configurations.
On
Turns on a viewport, making it active and making its objects visible.
Off
Turns off a viewport. When a viewport is off, its objects are not displayed,
and you cannot make that viewport current.
VPORTS Command Line | 1281
Need help?
Do you have a question about the AUTOCAD 2006 and is the answer not in the manual?