Autodesk AUTOCAD 2006 Command Reference Manual page 624

total length
object selected
Total Length
Lengthens the object to the specified value from the endpoint that is closest
to the selection point.
Select an object to change or [Undo]: Select one object or enter u
The prompt repeats until you press ENTER to end the command.
Angle
Sets the included angle of the selected arc.
Specify total angle <current>: Specify an angle or press ENTER
Select an object to change or [Undo]: Select one object or enter u
The prompt repeats until you press ENTER to end the command.
total angle
object selected
Dynamic
Turns on Dynamic Dragging mode. You change the length of a selected object
by dragging one of its endpoints. The other end remains fixed.
Select an object to change or [Undo]: Select one object or enter u
The prompt repeats until you press ENTER to end the command.
600 | Chapter 13