Autodesk AUTOCAD 2006 Command Reference Manual page 910

Offset Relative to Printable Area
Calculates the offset values that you specify from the corner of the printable
area of the paper (not the corner of the paper).
Orientation
Indicates the rotation of the plot stamp in relation to the specified page.
The options are Horizontal and Vertical for each of the locations (for
example, Top Left Horizontal and Top Left Vertical).
Single Line Plot Stamp
If selected, places the plot stamp information in a single line of text. The
plot stamp information can consist of up to two lines of text, but the
placement and offset values you specify must accommodate text wrapping
and text height. If the plot stamp contains text that is longer than the
printable area, the plot stamp text will be cut off. If this option is cleared,
plot stamp text is wrapped after the third field.
Stamp Upside Down
Rotates the plot stamp upside down.
X Offset
Determines the X offset value that is calculated from either the corner of
the paper or the corner of the printable area, depending on which setting
you specify. If you specify Offset Relative to Paper Border, the offset value
is calculated so that the plot stamp information fits within the designated
paper size. If the offset value positions the plot stamp information beyond
the printable area, the plot stamp text is cut off.
Y Offset
Determines the Y offset value that is calculated from either the corner of
the paper or the corner of the printable area, depending on which setting
you specify. If you specify Offset Relative to Paper Border, the offset value
is calculated so that the plot stamp information fits within the designated
paper size. If the offset value positions the plot stamp information beyond
the printable area, the plot stamp text is cut off.
Text Properties
Determines the font, height, and number of lines you want to apply to the
plot stamp text.
886 | Chapter 17