Autodesk AUTOCAD 2006 Command Reference Manual page 757

to navigate between pages; choose Finish on the last page to close the wizard
and create the new drawing with the settings you specified.
You can later change units, angle, angle measure, and angle direction using
the UNITS command, and you can change area using the LIMITS command.
Units
Indicates the unit format and precision. The unit format is the format in which
you enter and in which the program displays coordinates and measurements.
The Units page of the Quick Setup wizard includes the same formats. See "***
'Units' on page 5 ***" on page 731 for more information.
The unit precision specifies the number of decimal places or the fractional
size for displaying linear measurements.
Angle
Indicates the format in which you enter angles and in which the program
displays angles.
Decimal Degrees
Displays partial degrees as decimals.
Deg/Min/Sec
Displays partial degrees as minutes and seconds.
East
Specifies the compass direction east as the 0 angle.
Grads
Displays angles as grads.
North
Specifies the compass direction north as the 0 angle.
Other
Specifies a direction other than east, north, west, or south. Enter a specific
compass angle to treat as the 0 angle.
Radians
Displays angles as radians.
Advanced Setup Wizard | 733