Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine Installation Manual page 93

Chapter 5 Upgrading and Migrating to Cisco Secure ACS Solution Engine 4.1
Figure 5-5
Click Apply Upgrade.
j.
The upgrade utility applies the management software upgrade.
Note
Step 6 Download and apply the ACS Software Upgrade package.
a. Go to the /Upgrade package software for appliance ACS 4.1 folder on the upgrade CD.
b. Double-click the autorun.bat icon.
The download utility starts. You are prompted to enter the hostname of IP address of the appliance,
as shown in
c. Enter the hostname or the IP address of the distribution server and then click Install.
The ACS web interface starts.
Log in to the web interface.
d.
Choose System Configuration > Appliance Upgrade Status.
e.
The Appliance Upgrade page opens, as shown in
Download and install the software upgrade.
f.
The steps for downloading and installing the software upgrade package are the same as the steps for
installing the management software as described in
Note
OL-9969-03
Appliance Upgrade Page
This process takes several minutes. The system reboots several times.
Figure 5-1.
If you complete the upgrade and the ACS console displays the message
, this indicates that the upgrade progress is hanging.
progress
If this condition occurs, start an ACS console session and enter the command
, where
[hostAddress] hostAddress
console from the upgrade process.
Figure 5-2.
Step 5.
can be any IP address. This action releases the ACS
Installation Guide for Cisco Secure ACS Solution Engine 4.1
Upgrade Procedure
Appliance upgrade in
download
5-7