Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine Installation Manual page 115

Appendix C Command Reference
ntpsync
To perform Network Time Protocol (NTP) synchronization with a predefined NTP server, use the
ntpsync command. For information on setting the NTP server see
ntpsync
Syntax Description
This command has no arguments or keywords.
Example
The following command uses the predefined NTP synchronization server to synchronize ACS SE time
to the NTP server time:
ntpsync
lock guiadmin
To lock a GUI administrator account so that it cannot be used, use the lock guiadmin command:
lock guiadmin [admin] [password]
Syntax Description
admin
password
Usage Guidelines
During initial installation, the setup script prompts the installer to set up a GUI administration account
that remote users can use to access and configure the ACS solution engine. A GUI administrator account
can also be added by using the add guiadmin command.
GUI administrator accounts are not usable until they have been unlocked using the unlock guiadmin
command. The lock guiadmin command is provided to lock web GUI accounts that have been unlocked.
Example
The following command locks a GUI administrator account joeadmin with the password joltinjoe:
lock guiadmin joeadmin joltinjoe
ping
To send ICMP echo_request packets for diagnosing basic network connectivity, use the ping command:
ping [-t] [-a] [-n count] [-l size] [-f] [-i TTL] [-v TOS] [-r count] [-s count] [{-j
host-list}|{-k
OL-9969-03
Username for the GUI account.
Password for the GUI account.
h
ost-list}] [-w timeout] destination-list
Installation Guide for Cisco Secure ACS Solution Engine 4.1
Commands
set time, page C-13.
C-7