Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine Installation Manual page 54

Initial Configuration
Appliance Base Image: [version number]
CSA build [version number]: (Patch: [version number])
Status: Appliance is functioning properly
The ACS Appliance has not been configured.
Logon as "Administrator" with password "setup" to configure appliance.
Note If this information does not appear and only the login prompt appears, you must reboot the appliance
and then log in.
At the
Step 3
When you boot the system for the first time, it is not configured. You must log in as CLI administrator
Note
to configure the system.
Result: The system displays the
At the
Step 4
Note
Result: The system displays the following message on the console:
Initialize Appliance
Machine will be rebooted after initialization
Entering Ctrl-C before setting appliance name will shutdown the appliance
Step 5 At the
ACS SE, and then press Enter.
Tip
Result: The system displays the following message on the console:
ACS Appliance name is set to xxx.
At the
Step 6
Result: The system displays the following message on the console:
DNS name is set to xxx.com.
You need to set the administrator account name and password.
At the
Step 7
Enter.
Tip
At the
Step 8
Installation Guide for Cisco Secure ACS Solution Engine 4.1
3-12
prompt, type Administrator and then press Enter.
login:
prompt, type setup and press Enter.
password:
The password is case sensitive.
.
ACS Appliance name [deliverance1]:
The name can contain up to 15 letters and numbers, but no spaces.
prompt, type the domain name. Then press Enter.
DNS domain [ ]:
Enter new account name:
There is only one ACS SE CLI administrator account at a given time. This account allows access
only through a serial cable and CLI commands. The account's credentials can be changed. For
more information see Chapter 4, "Resetting the Solution Engine Administrator Password."
prompt, type the new ACS SE password and press Enter.
Enter new password:
Chapter 3 Installing and Configuring Cisco Secure ACS Solution Engine 4.1
prompt.
password:
.
prompt, type the name that you intend to use for your
prompt, type the ACS SE administrator account name, and then press
OL-9969-03