Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine Installation Manual page 67

Chapter 4 Administering Cisco Secure ACS Solution Engine
To restart an ACS service:
Log in to the ACS SE. For more information, see
Step 1
Console, page
Type restart followed by a single space and the name of the ACS service that you want to restart.
Step 2
Tip
Press Enter.
Step 3
Result: The system immediately displays the message:
service name is stopping. . .
Followed by the messages:
service name is not running
service name is starting
service name is running
Getting Command Help From the Serial Console
To obtain a list and description of commands on the ACS SE from the serial console:
Log in to the ACS SE. For more information, see
Step 1
Console, page
At the system prompt, type help, and then press Enter.
Step 2
Tip
Result: The ACS SE displays the list of commands and their descriptions, as shown in
Table 4-1
Command
?
add-guiadmin
backup
download
exit
exportgroups
exportlogs
exportusers
help
OL-9969-03
4-2.
You can list more than one service to restart; type a single space between each.
4-2.
Press Enter again to scroll through the list of commands, as necessary.
ACS SE Commands
Basic Command Line Administration Tasks
Logging In to the Solution Engine From a Serial
Logging In to the Solution Engine From a Serial
Description
List commands
Adds a GUI account that allows access to the SE
using the ACS web GUI.
Backup Appliance
Download ACS Install Package
Log off
Export group information to an FTP server
Export appliance diagnostic logs to FTP server
Export user information to an FTP server
List commands
Installation Guide for Cisco Secure ACS Solution Engine 4.1
Table 4-1.
4-7