Resetting The Solution Engine Administrator Password; Reconfiguring Solution Engine System Parameters - Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine Installation Manual

Chapter 4 Administering Cisco Secure ACS Solution Engine
At the
Step 10
data type Y and then press Enter.
Step 11 At the
and then press Enter.
Step 12 If you previously chose to decrypt the backup file, at the
password, and then press Enter.
Note
At the
Step 13
Result: The ACS SE receives the backup file from the specified location and displays messages
regarding the restoration. You may see warnings about components not included in the backup file. For
example, if ACS SE has no shared profile components configured, you see a message about DCS (device
command sets) not on the backup, which is normal.
When completed the system displays the message:
Done

Reconfiguring Solution Engine System Parameters

This section details basic reconfiguration tasks performed from a serial console connected the ACS SE.
This section contains:
•
•
•
•
•
•
•
•
•

Resetting the Solution Engine Administrator Password

There is always a single ACS SE administrator username and password that consists of the administrator
name and password. Unlike other ACS administrative accounts, this unique administrative account is
granted all privileges, cannot be deleted, and is not listed in the Administrators table of the
Administrative Control page in the ACS web interface. This account is called the CLI administrator
account and allows access to the SE only through a serial console.
OL-9969-03
CiscoSecure ACS System Configuration: (Y or N)
Decrypt Backup file? (Y or N)
The system displays a warning message:
Reloading a system backup will overwrite ALL current configuration information. All
services will be stopped and started automatically
Are you sure you want to proceed? (Y or N)
Resetting the Solution Engine Administrator Password, page 4-15
Resetting the Solution Engine CLI Administrator Name, page 4-16
Resetting the Solution Engine Database Password, page 4-18
Reconfiguring the Solution Engine IP Address, page 4-18
Setting the System Time and Date Manually, page 4-20
Setting the System Time and Date with NTP, page 4-20
Setting the System Timeout, page 4-21
Setting the Solution Engine System Domain, page 4-22
Setting the Solution Engine System Hostname, page 4-22
Reconfiguring Solution Engine System Parameters
prompt, to restore the system configuration
prompt, if you previously encrypted the backup file, type Y
Encryption Password:
prompt, type Y and then press Enter.
Installation Guide for Cisco Secure ACS Solution Engine 4.1
prompt, type the FTP
4-15