Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine Installation Manual page 118

Commands
AAA services are temporarily halted while this command executes.
Note
Syntax Description
This command uses as an argument the name of the service or services to be restarted.
Usage Guidelines
Use the restart command to stop and restart any of the ACS services. You can determine the status of
each service by using the show command. For more information, see
Services From a Serial Console, page
Example
The following command syntax restarts the CSAuth and CSAdmin services:
restart csauth csadmin
restore
To restore ACS data from an FTP server, use the restore command:
restore [server] [username] [filepath] [filename]
Syntax Description
Argument
server
username
filepath
filename
Usage Guidelines
If you do not enter the parameters, the system prompts you for the information. Also, you will be
prompted to enter a decrypt password; and you will be prompted to restore the user or group database,
and the ACS system configuration.
Example
The following command employs the user account joeadmin to retrieve a restore file, allofit, from the
restoredata folder on the topaz FTP server:
restore topaz joeadmin restoredata allofit
Installation Guide for Cisco Secure ACS Solution Engine 4.1
C-10
4-6.
Description
Hostname for the FTP server from which the file
will be sent.
User account name used to authenticate the FTP
session.
Location under the FTP server root in which the
restore file is located.
Name of the restore file to be used.
Appendix C Command Reference
Restarting Solution Engine
OL-9969-03