Exporting A List Of Users; Backing Up Acs Data From The Serial Console - Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine Installation Manual

Working with System Data

Exporting a List of Users

This section details the procedure for exporting a list of ACS SE users to an FTP server for further
examination and processing.
Before You Begin
You must have the FTP server address and pathname, as well as the proper credentials for writing to the
FTP server (username and password).
Performing this procedure stops and restarts the CSAuth service, and will interrupt use of the ACS SE.
Caution
To export a list of users to an FTP server:
Log in to the ACS SE. For more information, see
Step 1
Console, page
Step 2 Type exportusers.
Tip
Press Enter.
Step 3
Result: The system displays the message:
Command with restart CSAuth. Are you sure you want to continue?
Performing this procedure stops and restarts the CSAuth service, and will interrupt use of the ACS SE.
Caution
To proceed, type Y and press Enter.
Step 4
At the
Step 5
hostname and press Enter.
At the
Step 6
At the
Step 7
At the
Step 8
Result: ACS SE exports the file of the list of users to the specified location, and then displays the
message:
Transferring 'users.txt' completed
The system prompt reappears.

Backing Up ACS Data From the Serial Console

This section details how to use the serial console to back up ACS SE data to an FTP server.
Installation Guide for Cisco Secure ACS Solution Engine 4.1
4-12
4-2.
You can enter the following parameters after the command or in response to subsequent prompts:
[server] [username] [filepath]
Enter FTP Server Hostname or IP Address
prompt, enter the FTP server pathname and press Enter.
Directory:
prompt, enter your FTP server username and press Enter.
Username:
prompt, enter your FTP server password and press Enter.
Password:
Chapter 4 Administering Cisco Secure ACS Solution Engine
Logging In to the Solution Engine From a Serial
prompt, enter the FTP server IP address or
OL-9969-03