Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine Installation Manual page 79

Chapter 4 Administering Cisco Secure ACS Solution Engine
To set or change the IP address of your ACS SE, ACS SE must be connected to a working Ethernet
Note
connection.
To reconfigure the IP address:
Log in to the ACS SE. For more information, see
Step 1
Console, page
Type set ip, and then press Enter.
Step 2
At the
Step 3
If you answered No to using a static IP address, the system displays a confirmation of DHCP and the
Step 4
message
If you responded Yes in the previous step to use a static IP address:
To specify the ACS SE IP address, at the
a.
and then press Enter.
At the
b.
At the
c.
At the
d.
use (separate each by a single space), and then press Enter.
Result: The system displays the new configuration information and the message:
IP Address is reconfigured.
Review the information presented and, at the
Step 5
Result: The ACS SE restarts. The system displays the message:
New ip address is set.
At the prompt,
Step 6
Tip
At the prompt,
Step 7
to the ACS SE and then press Enter.
Result: If successful, the system displays the ping statistics. Once again the system displays the
network connectivity [Yes]:
If network connectivity is proven okay in the previous two steps, at the prompt,
Step 8
connectivity [Yes]:
Tip
Result: The ACS SE restarts services, and displays the system prompt.
OL-9969-03
4-2.
Use Static IP Address [Y]:
IP Address is reconfigured
Subnet Mask [xx.xx.xx.xx]:
Default Gateway [xx.xx.xx.xx]:
DNS Servers [xx.xx.xx.xx]:
Test network connectivity [Yes]:
This step executes a ping command to ensure the connectivity of the ACS SE.
Enter hostname or IP address:
, type N, and then press Enter.
The system will continue to provide you with the opportunity to test network connectivity until
you answer N. This procedure gives you an opportunity, if required, to correct network
connections or retype the IP address.
Logging In to the Solution Engine From a Serial
prompt, type Y for yes or N for No, and then press Enter.
. Continue the procedure with
IP Address [xx.xx.xx.xx]:
prompt, type the subnet mask, and then press Enter.
prompt, type the default gateway, and then press Enter.
prompt, type the address of any DNS servers you intend to
Confirm the changes? [Y]:
, type Y, and then press Enter.
, type the IP address or hostname of a device connected
prompt.
Installation Guide for Cisco Secure ACS Solution Engine 4.1
Reconfiguring Solution Engine System Parameters
Step 5.
prompt, type the IP address,
prompt, press Enter.
Test network
Test
4-19