Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine Installation Manual page 32

ACS SE Hardware Description
The Ethernet connectors are designed for attaching an unshielded twisted pair (UTP) Ethernet cable
equipped with standard RJ-45 compatible plugs. Press one end of the UTP cable into the Ethernet
connector until the plug snaps securely into place. Connect the other end of the cable to an RJ-45 port
on a hub or other device, depending on your network configuration. Observe the following cabling
restrictions for 10BASE-T, 100BASE-TX, and 1000BASE-TX networks:
For 10BASE-T networks, use Category 3 or greater wiring and connectors.
•
For 100BASE-TX and 1000BASE-TX networks, use Category 5 or greater wiring and connectors.
•
The maximum cable run length is 328 feet (ft) or 100 meters (m).
•
Installation Guide for Cisco Secure ACS Solution Engine 4.1
1-8
Chapter 1 Cisco Secure ACS Solution Engine Overview
OL-9969-03