Assigning The Keypad; Thread Cutting Procedure - DURKOPP ADLER DAC BASIC - V 12-2010 Manual

12.7.2

Assigning the keypad

The keys are called smart keys which means that the different functionalities can be applied directly to these
keys.
These are programmed using the P key followed by pressing the corresponding key for about 2 seconds. Confirm
the selection by pressing OK.
L C P Min
t 52 20 - 0
25
12.8

Thread cutting procedure

Thread cutter ON: Press
L C P Min
1 02 01 0
t 02 10 0
t 02 11 0
t 02 20 0
t 02 21 0
© 2010 Dürkopp Adler AG
13 = Needle cooling
Max Unit Description
13 - Setting the input function for the OP1000 "F" key
0 = no function;
1 = on threading help;
2 = Bartack suppression/recall;
3 = Manual bartack;
4 = Half stitch;
5 = Full stitch;
6 = Direction finder position;
7 = Turning back
8 = Input function module 1;
9 = Input function module 2;
10 = Input function module 3;
11 = Switch high lift for walking foot;
12 = Ornamental Backtack;
13 = Needle cooling
. LED on
Max Unit Description
1 - Pedal setting to start the cutting process.
0 = Position -2;
1 = Position -1
359 ° Power on angle t 08 12 <= t 02 10 < t 02 11
359 ° Power off angle t 02 10 <= t 02 11 < t 08 13
255 ms Time lag for repeated switching on of the thread cutting magnets.
255 ms Time lag for switching off the thread cutter magnets
51
Setting the basic functions