DAC basic/classic
11
Loading and saving data
L
C
P
Min
t
51 10 0
t
51 11 0
When the dongle is being accessed parameter t 51 10/11 = 1 or 3 the red message LED flashes.
11.1
Saving data on the dongle and back up/ mach ID
L
C
P
Min
t
51 11 0
After selecting the saving medium with parameter t 51 11 and confirming by pressing button OK (19) , the seam
runs and the seam-specific parameters are saved on the this medium. If the medium is not available a message
will appear and no action will be triggered.
11.2
Importing data to the dongle and the back up/ mach ID
L
C
P
Min
t
51 10 0
Max
Unit
Description
4
-
Loading parameters
0 = Nothing;
1 = Sewing data from DA dongle;
2 = Sewing data from the back up area;
3 = Seam runs from DA dongle;
4 = Master Reset
3
-
Saving parameters
0 = Nothing;
1 = Sewing data on the DA dongle;
2 = Sewing data in the back up area;
3 = Seam runs on the DA dongle
CAUTION
Only remove the dongle data memory from the port when the red LED has gone out.
Otherwise there is a risk of data loss and the control functions may no longer run
reliably.
Max
Unit
Description
3
-
Saving parameters
0 = Nothing;
1 = Sewing data on the DA dongle;
2 = Sewing data on the back up area;
3 = Sewing runs on the DA dongle
Max
Unit
Description
3
-
Loading parameters
0 = Nothing;
1 = Sewing data from DA dongle;
2 = Sewing data from the back up area;
3 = Seam runs from DA dongle;
4 = Master Reset
44
Loading and saving data
© 2010 Dürkopp Adler AG