DURKOPP ADLER DAC BASIC - V 12-2010 Manual page 130

Grad Code Fehler- bzw. Info- Beschreibung Abhilfe
Information 3103 Low voltage warning (1st threshold)
(mains voltage < 180V AC)
Warning 3104 Pedal position is not at position 0
Error 3105 Short circuit U24V
Error 3106 Overload U24V (I²T)
Error 3107 Pedal not connected
Warning 3109 Maintaining safety
Information 3150 Maintenance required (info)
Warning 3151 Maintenance required (continue only
when parameters reset
t 51 14, see machine's operating
instructions)
Information 3215 Bobbin thread ounter (info value 0
reached)
Information 3216 Bobbin thread monitor left
Information 3217 Bobbin thread monitor right
Information 3218 Bobbin thread monitor left and right - Change left and right bobbin
Error 6353 Internal EEprom communication
error
Error 6351 External EEprom communication
error
Information 6360 No valid data on external EEprom
Information 6361 No external Eeprom connected
Information 6362 No valid data on internal EEprom
Information 6363 No valid data on internal or external
EEprom
(only emergency run features)
Information 6364 No valid data on internal EEprom
and external EEprom not connected
(only emergency run features)
Information 6365 Internal EEprom faulty
Information 6366 Internal EEprom faulty and external
data invalid
(only emergency run features)
Information 6367 Internal EEprom faulty and external
not connected
© 2010 Dürkopp Adler AG
Error-, warning- and info-messages
- Check mains voltage
- Stabilise mains voltage
- Use generator
When switching on the control unit, take foot off pedal
- 37 pin Take plug out, if error 3105 continues, replace
control unit
- Test inputs/ outputs for 24V short circuit
- one or more of the magnets faulty
- connect analogue pedal
- Check the tipping sensor on the machine
- For information on lubricating the machine see the
machine's service instructions
- carry out service urgently, see machine's service
instructions
- Change reel, set counter value - press counter reset
button
- Change left bobbin
- Change right bobbin
- Switch off control unit, wait until the LEDs go out and
turn on again.
- Switch off control unit, wait until the LEDs go out and
check the connection of the mach-ID. Turn the control
on.
- Update software. The internal data structures are not
compatible with the external data memory
- Plug in mach ID
- Check connection mach-ID
- Switch off control unit, wait until the LEDs go out and
turn on again.
- Update software. The internal data structures are not
compatible with the external data memory
- Check connection mach-ID
- Switch off control unit, wait until the LEDs go out and
turn on again.
- Update software. The software version is not
compatible with the internal data memory
- Check connection mach-ID
- Switch off control unit, wait until the LEDs go out and
turn on again.
- Update software. The internal data structures are not
compatible with the external data memory
- Replace control unit
- Replace control unit
- Replace control unit
63