Important Safety Instructions - DURKOPP ADLER DAC BASIC - V 12-2010 Manual

1

Important safety instructions

This DAC or DAC
basic classic
and safety regulations in force and left the factory in a perfectly safe condition.
The user must observe all instructions and warning notices contained in these operating instructions in order to
maintain this condition and guarantee safe operation.
Any other use or use exceeding that specified, e.g. in the open air, in a wet or hazardous explosive environment is
an infringement of use for intended purpose. Use for the intended purpose includes observing the manufacturer's
prescribed conditions for operating, maintenance and repair.
The DAC or DAC
basic classic
operating instructions and its intended use.
These operating instructions must be read carefully before unpacking and commissioning the DAC
. Familiarize yourself with the safety, assembly, operating and maintenance instructions before you use the
classic
DAC or DAC , its accessories and its additional attachments for the first time.
basic classic
All operations on and with the DAC
general and particular safety instructions in the following sections of the operating instructions.
Any people who are involved with this must be made aware of these safety instructions and must comply with
them. Non-compliance with the safety instructions may lead to personal injury, damage to equipment or
malfunctions of and damage to the drive itself.
The accident prevention regulations in force in the respective user's country and the rules for safe, professional
working must be obeyed. The drive must only be assembled and commissioned by people trained in this.
Installation and commissioning of the DAC
that the effects of interference that may cause a risk to health for the staff and dangerous conditions are reduced
to a minimum. Working on live parts and equipment is not permitted. Exceptions are governed by EN 50110.
Before removing covers, fitting additional attachments or accessories e.g. reference value transmitters, photo
sensors etc., the control unit must be switched off, disconnected from the mains and you must wait until the
machine has stopped [DIN VDE 0113 Part 301; EN 60204-3-1; IEC 204-3-1].
To reduce the risk of burns, fire, electric shock or injuries, alterations or modifications to the DAC
are strictly forbidden.
No covers or protective devices may be removed during operation. Before leaving the work place the machine's on/
off switch must be switched to the off position. If it is to be idle for long periods the mains plug must be removed
so that the drive cannot be switched on accidentally.
If additional attachments or equipment are connected to the DAC
operated at low voltage that is produced by a safety transformer.
Do not put your hands near moving parts.
Do not operate the DAC
© 2010 Dürkopp Adler AG
sewing machine drive is manufactured and tested in accordance with the conditions
will only work safely and reliably if the control unit is used in accordance with these
or DAC
basic classic
or DAC
basic
or DAC if aerosols (sprays) or oxygen are being used.
basic classic
must only be carried out in compliance with the following
must be carried out carefully by skilled workers so
classic
or DAC
basic
5
Important safety instructions
basic
basic
control unit these may only be
classic
or DAC
or DAC
classic