Error-, Warning- And Info-Messages - DURKOPP ADLER DAC BASIC - V 12-2010 Manual

DAC basic/classic
14

Error-, warning- and info-messages

The control DAC or DAC
basic
described.
Grad Kürzel Beschreibung
Error Err Error
Switch off the control and eliminate the problem .
Warning Wrn Eliminate the state that caused to the warning. The control will normally worked.
Information Inf Information push the OK-button
Further working should be possible. It could be that only only emergency run features are
possible.
Grad Code Fehler- bzw. Info- Beschreibung Abhilfe
Error 1000 Sewing motor encoder plug (Sub-D,
9 pin) not connected.
Error 1001 Sewing motor error
Sewing motor plug (AMP) is not
connected.
Error 1002 Sewing motor insulation error
Error 1004 Sewing motor turning in the wrong
direction
Error 1005 sewing motor blocked
Error 1006 maximum speed exceeded
Error 1007 Errors in the reference movement
Error 1052 Excess sewing motor current,
internal current increase >25A
Error 1055 Sewing motor overload
Information 1203 Position not reached (for thread
cutting, turning round etc. )
Error 3100 AC RDY timeout , intermediate
circuit voltage has not reached the
defined threshold in the given time.
Error 3101 High voltage error, mains voltage
>290V for some time
Error 3102 Low voltage failure (2nd threshold)
(mains voltage < 150V AC)
has got three groups of messages. In the following table this three groups are
classic
Error-, warning- and info-messages
- Insert the encoder lead into the control unit. Use the
right interface.
- Check the connection and if necessary plug in.
- Test sewing motor phases (R= 2.8 Ohm, high
resistance compared with PE)
- Replace sewing motor
- Replace control unit
- Check motor phase and PE for low-resistance
connection
- Replace sewing motor
- Replace encoder
- Check that the motor plug is in the right place and
change if necessary
- Check wiring in the machine distributor and change if
necessary
- Test motor phases and check for value
-Eliminate sluggish movement in the sewing machine
- Change the Encoder
- Reset the control unit
- Check the machine sub class ( t 51 04)
- Change the encoder
- Eliminate sluggish movement in the sewing machine
- Replace control unit
- Eliminate sluggish movement in the sewing machine
- Check controller settings and if necessary change,
mechanical changes to the machines, e.g. thread
cutter setting, belt tension etc.)
- Check the t
hread lever up position (Position 2)
- Check mains voltage
- If mains voltage OK, replace control unit
- Check mains voltage, if rated voltage exceeded
permanently - stabilise or use generator
- Check mains voltage
- Stabilise mains voltage
- Use generator
62
© 2010 Dürkopp Adler AG