Table of Contents
Advertisement
The BigIron RX-32 chassis ships in a wooden crate, bolted to an inner pallet, and resting on an
outer pallet. Follow the steps given below to uncrate the chassis.
NOTE
To uncrate the BigIron RX-32 chassis, the crate must be in the upright (vertical) position.
1. Position the crate so that you have access to the front and the rear. There must be enough
2. Use a power drill with Phillips and large blade screwdriver attachments to remove the bolts and
FIGURE 40
3. Remove the remaining bolts and screws along the bottom of the crate that attach the crate to
4. Slide the sides, top, and back of the crate backwards as one unit until it clears the pallet.
5. Save the crate (including the shipping panel) in case the chassis needs to be shipped again.
Installing a BigIron RX-32 chassis in a rack
This section describes the following tasks:
•
•
BigIron RX Installation Guide
53-1001811-01
space to the rear of the pallet to slide and remove the crate.
screws that hold the front shipping panel in place, as shown in
shipping panel and set it aside.
Removing bolts and screws on the BigIron RX-32 chassis
the pallet.
Preparing to Mount a BigIron RX-32 chassis in a Rack
Attaching mounting brackets to a chassis
Installing a BigIron RX-32 switch
Figure
40. Remove the front
2
59
Advertisement
Table of Contents
