Table of Contents
Advertisement
FPGA image
The FPGA image is named "MBRIDGE" and serves as the interface between the management
module and the backplane. It is loaded on the management module only.
Startup configuration file
The Startup Configuration file contains a default configuration that is loaded at the factory and
appended with commands for the user. It is loaded on the management module only.
Software image naming conventions
This section describes the alpha-numeric scheme used to define the names of the image files used
to operate a BigIron RX Series switch.
the paragraphs that follow describe what each of the fields in the image name represents.
FIGURE 88
To identify the software image, the naming conventions encode a specific meaning for each of the
variables in the following syntax:
R indicates the software image is used on BigIron RX Series switches.
A indicates the module type:
•
•
B indicates the software type:
•
•
•
C is only used with IronWare management Images. it indicates:
•
BigIron RX Installation Guide
53-1001811-01
Software naming syntax
R A B [C]<XXYZZ>[x]
r = router (only used for IronWare Image)
b = boot, p = Ironware
m = management, l = line card module
If the value of A is m, the image supports a management module.
If the value of A is l, the image supports an interface module.
If the value of B is r, the image contains management IronWare application software.
If the value of B is p, the image contains interface IronWare application software.
If the value of B is b, the image contains Boot-Monitor system software.
If the value of C is r, the image contains IronWare management application software.
Software image naming conventions
Figure 88
illustrates the structure of the image names and
Major Release
Minor Release
Maintenance Release
Patch Release
7
165
Advertisement
Table of Contents
