Table of Contents
Advertisement
2
Verifying proper operation
TABLE 13
LED
Interface module
Pwr
Mgmt Act
82
Desired and abnormal LED states after system power on (Continued)
Desired state
Meaning
On
The module is
receiving power.
During
The active
initialization:
management
steady blinking.
module's processor
After initialization:
and the interface
occasional
module's processor
blinking.
are communicating.
Abnormal
Meaning or action
state
Off
The module is not receiving power.
You can do the following:
•
Make certain that the
module is installed properly.
For more information, refer to
"Installing BigIron RX-4
modules"
"Installing BigIron RX-8
modules"
"Installing BigIron RX-16
modules"
"Installing BigIron RX-32
modules"
•
The module may not be
receiving enough power.
Brocade recommends
installing power supplies in a
fully redundant configuration
as described in
power supplies in a BigIron
RX-4 chassis"
"Installing power supplies in
the BigIron RX-8 chassis"
page 44,
supplies in a BigIron RX-16
chassis"
on page 54, or
"Installing power supplies in
a BigIron RX-32 chassis"
page 75.
•
Check the Pwr LED on the
management module. If it is
on, this module may be
holding the power from the
interface module.
•
Enter the show chassis
command at any level of the
CLI to determine if the
management module
recognizes the presence of
all power sources.
•
If using AC power supplies,
see the entry for the AC
power supply LED in this
table for more information.
Off for an
The interface module may be in
extended
interactive mode. Check the
period.
status of the module by entering
the show module command at any
CLI prompt.
BigIron RX Installation Guide
on page 33,
on page 42,
on page 52, or
on page 62.
"Installing
on page 35,
on
"Installing power
on
53-1001811-01
Advertisement
Table of Contents
