Dell PowerConnect B-RX16 Installation Manual page 113

•
•
NOTE
You cannot assign a password using the Web management interface. You can assign passwords
using the IronView Network Manager if an Enable password for a Super User is already configured
on the device.
You can set the following levels of Enable passwords:
•
•
•
To set passwords:
1. At the opening CLI prompt, enter the following command to change to the Privileged level of the
2. Access the CONFIG level of the CLI by entering the following command:
3. Enter the following command to set the super-user password:
4. Enter the following commands to set the port configuration and read-only passwords:
Syntax: enable super-user-password | read-only-password | port-config-password <text>
Passwords can be up to 48 characters long.
BigIron RX Installation Guide
53-1001811-01
Privileged EXEC – This level is also called the Enable level and can be secured by a password.
You can perform tasks such as manage files on the management module's flash memory or a
PCMCIA flash card in the management module's slots 1 or 2, save the system configuration to
flash memory, and clear caches at this level.
CONFIG – The configuration level. This level lets you configure the system's IP address and
configure routing features. To access the CONFIG mode, you must already be logged into the
Privileged level of the EXEC mode.
Super User – Allows complete read-and-write access to the system. This is generally for system
administrators and is the only password level that allows you to configure passwords.
NOTE
You must set a super user password before you can set other types of passwords.
Port Configuration – Allows read-and-write access for specific ports but not for global
(system-wide) parameters.
Read Only – Allows access to the Privileged EXEC mode and CONFIG mode but only with read
access.
EXEC mode:
BigIron RX> enable
BigIron RX#
BigIron RX# configure terminal
BigIron RX(config)#
BigIron RX(config)# enable super-user-password <text>
NOTE
You must set the super-user password before you can set other types of passwords.
BigIron RX(config)# enable port-config-password <text>
BigIron RX(config)# enable read-only-password <text>
Assigning passwords
4
101