Dell PowerConnect B-RX16 Installation Manual page 43

To perform this task, you need a #2 Phillips-head screwdriver.
FIGURE 17
1
2
Mounting a BigIron RX-4 chassis in a rack
Follow the steps given below to mount a BigIron RX-4 chassis in a rack.
1. Determine the position of each chassis in the rack, for example, a chassis with the fewest
2. Position two of the four screws for each chassis according to the spacings of the keyhole slots
FIGURE 18
1
BigIron RX Installation Guide
53-1001811-01
Removing the extra screws used for shipment
1
3
Chassis front
Shipping screws
modules on top, a chassis with more modules than the top chassis in the middle, and a fully
populated chassis on the bottom.
on the mounting brackets as shown in
approximately 1/4 inch of clearance between the back of the screw head and the rack.
Positioning the screws in a rack
1
Unequal flange equipment rack
Installing a BigIron RX-4 switch
3 Chassis rear
Figure 18. Do not secure the screws completely; leave
2 Network equipment rack
2
2
2
31