Table of Contents
Advertisement
2
Installing a BigIron RX-4 switch
•
DANGER
For safety reasons, the ESD wrist strap should contain a 1 meg ohm series resistor.
•
Follow the steps given below to install a module in the BigIron RX-4 chassis.
1. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector on
2. Remove the module from its packaging.
3. With the ejectors in the outward position, insert the module into the appropriate chassis slot
FIGURE 20
1
4. Push the ejectors in until they are flush with the module front panel. This action will fully seat
5. Tighten the two screws at either end of the module front panel by pushing them in and turning
34
An ESD wrist strap with a plug for connection to the ESD connector on the BigIron RX-4 chassis.
A large flat-head screwdriver.
the chassis front.
and slide the card along the card guide until the ejectors on either side of the module move
close to the module front panel.
Installing a module in a BigIron RX-4 chassis
1
Interface module
NOTE
When inserting the module into the chassis, make sure that the faceplate does not overlap
with the faceplate of an adjacent interface module.
the module in the backplane. Modules have a snug fit for maximum EMI protection.
NOTE
The installation instructions for installing modules shown in the following illustrations are
exactly the same for interface, management, and switch fabric modules.
them clockwise. Then, tighten the screws further using the flat-head screwdriver.
BigIron RX Installation Guide
53-1001811-01
Advertisement
Table of Contents
