Table of Contents
Advertisement
6. Gently pull the release latch on the power supply front panel upward and toward the top of the
7.
8. For information about powering on the system, refer to
Connecting AC power to a BigIron RX-32 chassis
AC power is supplied through an AC power cord that is installed in the front of each power supply in
the BigIron RX-32 chassis.
1. At the front of the BigIron RX-32 chassis, locate the power receptacle on the front panel of
2. Lift the cord retainer and connect a Brocade-supplied AC power cord to the power supply.
3. Snap the cord retainer over the power plug to hold it in place.
FIGURE 55
1
Final steps
You should complete the final step in the order in which they are listed:
•
•
•
Attaching a management station
You can manage the BigIron RX Series system in the following ways:
•
BigIron RX Installation Guide
53-1001811-01
power supply front panel. This action locks the power supply in place.
For information about connecting power to the chassis, refer to
BigIron RX-32 chassis"
on page 77.
page 79.
each power supply that has been installed. Refer to
BigIron RX-32 power supply receptacle and cord retainer
AC OK
DC OK
ALM
Cord retainer
"Attaching a management station"
"Powering-on the power source"
"Verifying proper operation"
You can connect a PC or terminal to the management module's serial (Console) port for a
direct connection. From this interface, you can configure the
10BaseT/100BaseTX/1000BaseTX Ethernet (management) port with an IP address and either
Telnet or SSH. This enables you to manage the device through the
10BaseT/100BaseTX/1000BaseTX Ethernet (management) port using either Telnet or SSH.
Attaching a management station
"Powering-on the power source"
Figure
55.
2
Power receptacle
"Connecting AC power to a
on
1
2
2
77
Advertisement
Table of Contents
