Configuration When The Remote Gateway Uses A Dynamic Ip Address - Cisco RVS4000 - Gigabit Security Router Administration Manual

Gateway-to-Gateway VPN Tunnel

Configuration when the Remote Gateway Uses a Dynamic IP Address

Configuration when the Remote Gateway Uses a Dynamic IP
Address
NOTE
STEP 1
Cisco RVS4000 Security Router with VPN Administrator Guide
This example assumes the Remote Gateway is using a dynamic IP address. If the
Remote Gateway uses a static IP address, refer to
Remote Gateway Uses a Static IP Address," on page
Gateway-to-Gateway IPSec VPN Tunnel - Remote Gateway Using
Dynamic IP
Each computer must have a network adapter installed.
Configuration of the RVS4000.
Follow these instructions for the first VPN router, designated RVS4000. The other
VPN router is designated the RV082.
a. Launch the web browser for a networked computer, designated PC 1.
b. Access the configuration utility of the RVS4000. (Refer to
Up and Configuring the Router"
c. Click VPN > IPSec VPN.
d. Enter a name in the Tunnel Name field.
e. For the IPSec VPN Tunnel setting, select Enable.
f. The WAN IP address (A.A.A.A) of the RVS4000 will be automatically detected.
"Configuration when the
167.
for details.)
D
Chapter 5, "Setting
172