General Policy Troubleshooting; Section A.5, "General Policy Troubleshooting - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - POLICY MANAGEMENT REFERENCE 10.3 30-03-2010 Management Manual

A.5 General Policy Troubleshooting
"The user is prompted to log in again immediately after logging in to ZENworks by using
ZENworks icon" on page 72
"Unable to view the newly added user source in all the other concurrent sessions of ZENworks
Control Center" on page 72
"The Wake-on-LAN policy is not available in ZENworks Configuration Management" on
page 73
"The zman pvst command might not display the correct status of the policy assignment and
deployment on a managed device" on page 73
"The enforcement of policies such as DLU policy, Roaming Profile policy, or Group Policy
fails on the managed device" on page 73
"Closing a published application or logging out of the shared desktop of a Citrix server fails to
terminate the session on the Citrix server" on page 73
The user is prompted to log in again immediately after logging in to ZENworks by
using ZENworks icon
Explanation: If the following conditions are met, a ZENworks user is prompted to log in
Unable to view the newly added user source in all the other concurrent sessions of
ZENworks Control Center
72 ZENworks 10 Configuration Management Policy Management Reference
Action: Before the policy is assigned to the device or the device is disconnected from
the network, perform the following steps on the managed device to use the
user source password for logging in to the device:
1 Open the Registry Editor.
2 Go to \
HKLM\SOFTWARE\Novell\NWGINA\Dynamic Local User
3 Create a DWORD called
to 1.
Source: ZENworks 10 Configuration Management; Policy Management.
again immediately after logging in to the device, in spite of providing the right
credentials:
The user has logged in to a device where another ZENworks user has
logged in and logged out within 5 to 10 mins of the desktop login.
The Dynamic Local User policy or the Windows Group policy that is
assigned to the user has the After enforcement, force a re-login on the
managed device, if necessary option selected.
Action: Edit the policy to deselect After enforcement, force a re-login on the managed
device, if necessary.
Source: ZENworks 10 Configuration Management; Policy Management.
EnableEDirPasswordForFA
\.
, and set the value