Windows Group Policy - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - POLICY MANAGEMENT REFERENCE 10.3 30-03-2010 Management Manual

Field
Add a Trap Target
IP Address / Host Name
Community String
Remove All SNMP Trap
Targets Not Specified by
ZENworks SNMP Policies
This page allows you to add only one trap target to the policy. If you want to add multiple trap
targets, then configure them in the Details page after creating the policy.
7 Click Next to display the Default System Requirements for SNMP Policy page, then use the
options to specify the settings. Refer to the following table for more information:
Field
Apply Policy Only if SNMP
Service Exists On the Target
Device
8 Click Next to display the Summary page.
9 Click Finish to create the policy now, or select Define Additional Properties to specify
additional information, such as policy assignment,
and which group the policy is a member of.

2.8 Windows Group Policy

The Windows Group Policy allows you to configure a Group Policy for Windows devices.
1 In ZENworks Control Center, click the Policies tab.
2 In the Policies list, click New, then click Policy to display the Select Policy Type page.
3 Select Windows Group Policy, click Next to display the Define Details page, then fill in the
fields:
Policy Name: Provide a name for the policy. The policy name must be different than the name
of any other item (group, folder, and so forth) that resides in the same folder. The name you
provide displays in ZENworks Control Center.
Folder: Type the name or browse to and select the ZENworks Control Center folder where you
want the policy to reside. The default is
organize your policies.
Description: Provide a short description of the policy's content. This description displays in
ZENworks Control Center.
4 Click Next to display the Windows Group Policy Settings page, then use the options to specify
the settings. Refer to the following table for more information:
30 ZENworks 10 Configuration Management Policy Management Reference
Details
Allows you to add a trap target for the SNMP service.
Specify an IP address or host name of the target device.
Specify a community string for the trap target defined in IP address/
Host name.
Select this option to remove all the trap targets that are not
specified through the ZENworks SNMP policy.
Details
Select this option apply the SNMP policy only if the SNMP service
exists on the target device. If the target device does not contain
the SNMP service, the SNMP policy cannot be fully applied or
effective on the target device.
system
, but you can create additional folders to
/policies
requirements, enforcement, status,