Disabling Policies; Enabling The Disabled Policies; Copying A Policy To A Content Server; Section 3.12, "Disabling Policies - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - POLICY MANAGEMENT REFERENCE 10.3 30-03-2010 Management Manual

For example, "(u AND v AND w) OR (x AND y AND z)" means "match either uvw or xyz." In the
filter list, this looks like:
u AND
v AND
w
OR
x AND
y AND
z
Nested Filters and Filter Sets
Filters and filter sets cannot be nested. You can only enter them in series, and the first filter or filter
set to match the device is used. Therefore, the order in which they are listed does not matter. You are
simply looking for a match to cause the policy to be applied to the device.

3.12 Disabling Policies

When you create a policy in ZENworks Configuration Management, the policy is enabled by
default. Policies can be disabled by an administrator. If a policy is disabled, it is not considered for
enforcement on any of the devices and users that it applies to.
To disable a policy:
1 In ZENworks Control Center, click the Policies tab.
2 Select the check box next to the policy (or policies) that you want to disable.
3 Click Action > Disable Policies.
In the Policies list, the status of Enabled for the policy (or policies) is changed to No.
When you disable a policy that has already been enforced for some managed devices and users,
the policy is removed from those devices and it is not enforced for new devices and users.

3.13 Enabling the Disabled Policies

1 In ZENworks Control Center, click the Policies tab.
2 Select the check box next to the policy (or policies) that you want to enable.
3 Click Action > Enable Policies.
In the Policies list, the status of the Enabled column for the policy (or policies) is changed to
Yes.

3.14 Copying a Policy to a Content Server

By default, a policy is copied to each content server. If you specify certain content servers as hosts,
the policy is hosted on only those content servers; it is not copied to all content servers. You can also
specify whether the selected policy is replicated to new content servers (ZENworks Servers and
satellite servers) that are added to the Management Zone.
To specify a content server:
1 In ZENworks Control Center, click the Policies tab.
Managing Policies 55