Figure 9-6
Section 9.4.1, "Accessing the Hex Editor," on page 156
Section 9.4.2, "Importing Data into the Hex Editor," on page 157
Section 9.4.3, "Inserting Data in the Hex Editor," on page 157
Section 9.4.4, "Appending Data in the Hex Editor," on page 158
Section 9.4.5, "Editing Data in the Hex Editor," on page 159
Section 9.4.6, "Reverting Changes in the Hex Editor," on page 161
Section 9.4.7, "Deleting Data in the Hex Editor," on page 161
Section 9.4.8, "Moving the Cursor in the Hex Editor," on page 162
Section 9.4.9, "Exporting Data from the Hex Editor," on page 162
9.4.1 Accessing the Hex Editor
The Hex editor is inside of the Policy Simulator. The Hex editor is opened for all attributes that have
an eDirectory syntax of octet string or unknown and an application syntax type of octet. You can
also access the Hex editor by following these steps:
1 Launch the Policy Simulator and do the following:
1a Set the Simulation Point to Publisher Creation.
156 Policies in Designer 3.5
Hex Editor