Save The Input Document; Simulation Point - Novell POLICY IN DESIGNER 3.5 - 09-18-2009 Manual

4 Click OK.

9.2.7 Save the Input Document

The Policy Simulator does not store the input document for future sessions in Designer. If you want
to use the input document for a later session in Designer, the input document must be saved.
1 In the toolbar, click Save
2 Browse to a location where you want to save the file, then specify a filename.
3 Click Save to save the input document.
®
Novell recommends that you do not save the input document in the same directory where Designer
is installed or it might be overwritten during a Designer upgrade.

9.2.8 Simulation Point

The Policy Simulator allows you to select a policy set or group of policies to simulate with a specific
operation.
Figure 9-2
You can select a Driver object, Publisher channel, Subscriber channel, policy, or rule as the
simulation point. If you select a Driver object, Publisher channel, or Subscriber channel, the
Simulation Point options are:
Input
Schema Map Inbound
Publisher Event
Publisher Sync Filter
Publisher Matching
Publisher Creation
NOTE: If you want to test a single policy, launch the simulator from the selected policy. If you do
select a specific policy or rule to test, the Simulation Point options are To Identity Vault and From
Identity Vault.
150 Policies in Designer 3.5
.
Simulation Point in the Policy Simulator
Publisher Placement
Publisher Command
Publisher Notify Filter
Output
Schema Mapping Outbound
Subscriber Notify Filter
Subscriber Command
Subscriber Placement
Subscriber Creation
Subscriber Matching
Subscriber Event
Subscriber Sync Filter