Condition Argument Component Builder; Match Attribute Builder; Section 16.6, "Condition Argument Component Builder; Section 16.7, "Match Attribute Builder - Novell POLICY IN DESIGNER 3.5 - 09-18-2009 Manual

New > Insert Condition After: Adds a condition after the current condition.
Edit: Launches the Condition Builder.
Move the selected item up: Moves the selected condition up in the order of execution.
Move the selected item down: Moves the selected condition down in the order of
execution.
Cut, Copy, Paste, or Delete: Cuts, copies, pastes, or deletes the condition.
Undo or Redo: Undoes or redoes the last action.
Preferences: Allows you to set default functionary in the Policy Builder.
Help: Select a condition, then click the Help icon to see information specific to that
condition.
For additional information on the Condition Builder and the rules, see
Rule," on page 28.

16.6 Condition Argument Component Builder

To launch the Condition Argument Component Builder, select one of the following conditions, then
select the structured selection for Mode in order to see the Launch ArgComponent Builder icon
If Attribute (page 393)
If Destination Attribute (page 397)
If Association (page 392)
If Attribute mode
Figure 16-5
1 Specify the name and value of the condition component.
2 Click Finish.

16.7 Match Attribute Builder

The Match Attribute Builder enables you to select attributes and values used by the
Object (page 437) action to determine if a matching object exists in a data store.
Section 3.4, "Creating a
Find Matching
Pre-Identity Manager 3.5 Builders 383
.