Post-Installation; Labeling Tapes - Novell OPEN WORKGROUP SUITE SMALL BUSINESS EDITION 9.3 - INSTALLATION AND ADMINISTRATION GUIDE 10-2007 Administration Manual
Hide thumbs
Also See for OPEN WORKGROUP SUITE SMALL BUSINESS EDITION 9.3 - INSTALLATION AND ADMINISTRATION GUIDE 10-2007:
- Manual (23 pages)
Table of Contents
Advertisement
6 The Amanda Basic installation is now complete. Click Finish to proceed to the available
software page. Amanda is now listed on the installed software list and can be launched from the
Amanda administration link.
6.3 Post-Installation
Section 6.3.1, "Labeling Tapes," on page 43
Section 6.3.2, "Backup Scheduling and Configuration," on page 44
6.3.1 Labeling Tapes
This needs to be done after installation of Amanda in tape mode.
1 Su to user amandabackup.
2 Write DailySet1-XX on the tape, where XX is the number of the tape.
3 Load the tape into the drive.
4 Run the command amlabel DailySet DailySet1-XX.
You need to change tapes manually before backup time. Amanda does not overwrite the wrong tape,
so the appropriate tape must be inserted prior to the selected backup time.
If you are using a tape changer, you need to set the tape changer manually. Setting up the tape
changer is very specific to the device. For more information, see the
www.amanda.org/docs/tapechangers.html).
Amanda manual (http://
Network Backup (Amanda)
43
Advertisement
Table of Contents
Need help?
Do you have a question about the OPEN WORKGROUP SUITE SMALL BUSINESS EDITION 9.3 - INSTALLATION AND ADMINISTRATION GUIDE 10-2007 and is the answer not in the manual?
Questions and answers